BUILD A MECHANICAL PART

METHODOLOGY

CONTENT:

Mechanical part is the most important thing to see how the prototype of the project is look like. In order to make the prototype is complete, I have to consider a lot of part such as the motor shaft that have to put at the wheel of this vehicle, the prospect that need to cut by follow the size that can put all my circuit and also for the load space. All this thing I have to consider about the size, range also the space needed to ensure that the circuit can run smoothly without any over voltage or short circuit is happen. I take a lot of time to adjust the motor and motor driver part since it cannot move well by follow the line provided on the floor. To ensure that the motor can move faster, so I just use 3rpm motor since my supply voltage is not too higher.

OBJECTIVES: 

• To specified the actual size that needed for the prototype in this project.
• To complete up my project until the end of the process which is make it as one of the vehicle.
• To ensure that the motor can run by following the line beside know how to adjust and plug the motor correctly.

CONCLUSION:

By involve in this part, I can see how difficult to built a kind of vehicle that related with the motor shaft and motor driver. I have to consider about the movement of the vehicle that need to move forward, right or left side. I also have a problem on cutting the prospect that cannot cut by using common knife since the thickness of the prospect quite thick.So I need to hire a person that a have a suitable knife or machine to cut the prospect according to my specific size that I already measure before.At last all the part can combine together to make it become like kind of vehicle.